SAFETY TRANSFORMER GT 1990 12/24V

Name: GT 1990
Description: Safety transformer
• 12/24 V~ (5.2/2.6 A)

Description
• Installation in electrical distributor/flat distributor
• Short-circuit resistance through PTC
• Suitable for continuous load
• Meets the most stringent environmental requirements
• Tested according to EN 61558
• Certified by VDE and KEMA, identified by ENEC mark for use
throughout Europe
Technical data
• Primary: 230 V~ (50 Hz)
• 90 x 90 x 55 mm (corresponds to 5 installation modules)
Note
• Higher output voltage at low loads or no load!
• The secondary windings with cable links are to be connected
in series or parallel (see type label) depending on the
selected output voltage
• Following a short circuit, start-up is to be performed by
briefly disconnecting the primary side from the mains
Accessories for surface-mount installation set
• Incl. two covering caps for IP 20
• Incl. clamping rail and material for surface-mount installation