STANDARD BELL TRANSFORMERS (24 VA)

Description
• Installation in electrical distributor/flat distributor
• Short-circuit resistance through PTC
• Meets the most stringent environmental requirements
• Tested according to EN61558
• Certified by VDE and KEMA, identified by ENEC mark for use
throughout Europe
Technical data
• Primary: 230-240 V~ (50 Hz)
• 90 x 54 x 55 mm (corresponds to 3 installation modules)

Note
• Higher output voltage at low loads or no load!
• Following a short circuit, start-up is to be performed by
briefly disconnecting the primary side from the mains
• For short-term loads (for continuous loads we recommend
the use of GROTHE safety transformers)
Accessories for surface-mount installation set
• Incl. two covering caps for IP 20
• Incl. clamping rail and material for surface-mount installation